- #Mac ii emulator computer musem serial
- #Mac ii emulator computer musem manual
- #Mac ii emulator computer musem software
- #Mac ii emulator computer musem series
The CPU was a 100MHz PowerPC 604 with 256KB L2 cache, and the machine was equipped with 192MB RAM, which was the maximum it could handle.
#Mac ii emulator computer musem series
Windows NT was clearly the closest competitor of OS/2 PPC.įor this article, OS/2 PPC was installed on a Power Series 830, installed by its previous owner in a RS/6000 43P case. Linux also supported the Power Series to some extent. Most of the Power Series systems ended up running AIX, which supported them until version 5.1.
![mac ii emulator computer musem mac ii emulator computer musem](https://openemu.org/img/intro-nes-grid.png)
OS/2 PPC was only semi-finished, and the Solaris for PowerPC port (version 2.5.1) was similarly short-lived. Microsoft dropped PowerPC support in 1996, not long after the Windows NT 4.0 release. The machines were supposed to run OS/2, Windows NT, AIX, or Solaris. Unlike the RS/6000 systems intended for the workstation market and running almost exclusively IBM’s AIX operating system, the Power Series systems were designed for “regular” personal computer users. They used the same motherboard, only the RS/6000 had on-board SCSI controller. The RS/6000 Model 43P-7248 was nearly identical to the Power Series 850. The Power Series systems were closely related to certain IBM RS/6000 workstations. The desktops also had onboard Ethernet chips (AMD PCnet).
![mac ii emulator computer musem mac ii emulator computer musem](http://www.vintageisthenewold.com/wp-content/uploads/2015/04/virtual2-screenshot.png)
Several optional graphics cards were supported, notably Weitek P9100 based accelerators. The desktops had onboard S3 864 video, ThinkPads used Western Digital flat panel chipsets.
#Mac ii emulator computer musem serial
The computers had standard serial and parallel ports, as well as most of typical PC hardware such as interrupt and DMA controllers. The desktop Power Series machines were IDE based, ThinkPads used SCSI disks. They were designed around the PCI bus, but also included ISA expansion slots and on-board Crystal Audio ISA PnP chips. The PowerPC CPU aside, the systems were very similar to Intel based hardware of that era. The IBM Power Series computers were IBM’s rather short lived foray into the PowerPC-based desktop personal computer market, circa 1995-1996. Those were desktop models 830 and 850, and OS/2 PPC probably also supported the Power Series ThinkPads 820 and 850, though that can be only inferred from the fact that the graphics chipset employed by these ThinkPads was on the very short list of supported devices in OS/2 PPC. OS/2 PPC only supported an extremely limited range of hardware-IBM Personal Power Series machines. OS/2 PPC may not even had a box, although there were nice looking official CDs. The product was only available to a limited number of IBM customers and was never actively marketed. Following years of hype and high expectation, the release was very low key and in fact marked the end of development of OS/2 for PowerPC. For brevity, this release will be further referred to as OS/2 PPC. In December 1995, after unexpectedly long development (but is that really unexpected?), IBM finally “shipped” OS/2 Warp, PowerPC edition. Watch a YouTube video of II in a Mac in action.The PowerPC adventure-by far the most exotic release of OS/2 I haven't been able to locate any info on this product.
#Mac ii emulator computer musem software
The company also released a product called II-in-a-PC that allowed Apple II software to run on a PC. II-in-a-Mac had key disk copy protection but could be installed on a hard drive or double-sided Mac floppy disk. Copy protected Apple II software does not work with the emulator. Graphics could be cut and pasted from Apple II programs into Macpaint documents.
![mac ii emulator computer musem mac ii emulator computer musem](https://i1.rgstatic.net/publication/351321060_Emulation_practices_for_software_preservation_in_libraries_archives_and_museums/links/60a0b8cb458515c26595f402/largepreview.png)
Text could be cut and pasted in either direction between the Mac and Apple II applications using the clipboard. Extra Mac memory was used to emulate the Applied Engineering Ramworks II card. Average performance was about half the speed of an Apple II. Version 2.0 supported Apple IIe and IIc programs. " Emulator Lets Apple II Programs Run on a Mac " - This Infoworld article dated Jdiscusses version 2.0.
![mac ii emulator computer musem mac ii emulator computer musem](https://cdn-0.enacademic.com/pictures/enwiki/65/Apple-Macintosh.jpg)
#Mac ii emulator computer musem manual
User Manual - 45pp (17mb high resolution PDF) The emulator was created by Computer Applications, Inc., based in Raleigh, North Carolina. This was long before the appearance of the 1991 Apple IIe Card for the Mac LC. Initially it could run Apple II+ programs, but later evolved to include IIc and IIe software. The emulator ran on a 512K Mac and was released in November 1985. II in a Mac was the first Apple II emulator.